The HA PW2016 ~ 16P, an Unmanaged Switch, is designed for residential building in the corridor-level broadband switching equipment, for the edge of the access and LAN to provide high-quality network connections. It also provide the PoE function for powering of wireless LAN (WAN) access points, IP security cameras, VoIP telephone and other low port density installations. The HA PW2016 ~ 16P is a case-shaped device with a chassis of 1U high. It provides 16 10/100Base-TX ports. It provides 8/16 PoE Injector. Power-over-Ethernet (PoE) eliminates the need to run DC power to other devices on a wired LAN Using a Power-over-Ethernet system, installers need to run only a single Category 5 Ethernet cable that carries both power and data to each device. This allows greater flexibility In the locating of network devices and, in many cases, significantly decreases installation costs There are two system components in PoE – the PSE (Power Sourcing Equipment) and the PD (Powered Device) The IEEE 802.3af/at specification defines PSE as a device that inserts power onto an Ethernet cable. The PSE may be located at the switch or It may be a separate device located between the switch and the PD (Midspan configuration). The PD is the natural termination of this link, receiving the power, and could be an IP phone. a WLAN access point, or any other IP device that requires power, The current IS transmitted over two of the four twisted pairs of wires in a Category-5 cable Power-over-Ethernet follows the IEEE 802.3at/at specification and is completely compatible With existing Ethernet switches and networked devices. Because the Power Sourcing Equipment (PSE) tests whether a networked device IS PoE-capable, power is never transmitted unless a Powered Device is at the other end of the cable. It also continues to monitor the channel If the Powered Device does not draw a minimum current. because it has been unplugged or physically turned off, the PSE shuts down the power to that port Optionally, the standard permits Powered Devices to signal the PSEs exactly how much power they need The PoE switch is a multi-port fast ethernet switch that can be used to build high performance switched workgroup networks. This switch is a store and forward device that offers low latency for high-speed networking. It also features a ‘store-and-forward” switching scheme that allows the switch to auto learn and store source addresses In a BK-entry MAC address table The switch is targeted at workgroup, department or backbone computing environments SPECIFICATIONS Standard IEEE 802.3 10Base-T Ethernet Compliance IEEE 802.3u 100Base-TX Fast EthernetIEEE 802.3x Flow ControlIEEE 802.3af/at Power over Ethernet Transfer Rate 14,880 pps for 10Mbps148,800 pps for 100Mbps Connector 10/100TX: 16 × RJ-45 with auto MDI/MDI-X funtions;Port 1 ~ 16 support PoE injector function PoE pin assignment V (RJ45 Pin 4, 5), V- (RJ45 Pin 7, 8) MAC Address 8K MAC address table Switching capacity 4.8G LED Indicator Per port: Link/ActivityPer PoE port: PoEPer unit: Power Network Cable 2-pair UTP Cat. 5e cable (100m),EIA/TIA-568 100-ohm STP (100M) Dimen sion 440mm × 200mm × 44mm (W × D × H) Ventilation Built'in Noiseless FAN Operating Temp 0°C to 45°C (32°F to 113°F) Operating Humidity 10% to 90% (Non-condensing) Power Supply Built-in power supplyInput: AC 100 ~ 240V, 5O/60Hz Power Consumption 250 Watt EMI FCC Class B, CE
